$1,500

1978 scout 2

this weekKenosha, WI+42 milesAuto Parts for Sale
Bought them to make 1 out of 2. Good pieces. 345 engine, msd ignition, Clean. Manual tranny. Body is in decent shape. Enough to make 1 scout. Has hard top, 5 doors, back seat, dashes, etc. Good glass. One of them has 3/4 ton axles. Cool project. Text 5127738573 if interested
454 , 20 over, hyd cam, 781 oval port heads, sfi balancer, etc 454 30 over , nitrate crank, H beam, rods,. Somonauk, IL 60552 (630) 370-3712
91-92 trans am hatch pull down motor with hatch opener worked when pulled $50 i know someones hatch dont pull down and u have to slam it. have red fuel door for 82-92 F body . and interior plastics, dash, E brake 1LE rear calipers and rotors
Book is in really nice condition for Buick, Oldsmobile, and Pontiac Cars from 1975 - 1987.All U.S. and Canadian models of full-size, rear wheel drive BUICK Electra , LeSabre , Regal , Estate Wagon , OLDSMOBILE Delta 88 , Ninety-Eight , Custom Cruiser , Estate Wagon , PONTIAC Bonneville , Catalina , Grand Ville , Parisienne , Safari WagonFirst $5 Cash1976 , 1977 , 1978 , 1979 , 1980 , 1981 , 198...
I have a brand new strange alu. daytona 9" pinion support. it's part number N-1915. it also comes with the bearing races & O-ring. . it weights only 3 lbs with the races compared to the iron that weight 6.35 lbs. the 1st. $60.00 plus shipping gets it. any ?'s please E-mail me at [email protected] or call 1 312 502 6312. Monee, IL 60449 (312) 502-6312
i have a used strange alu. ultra 9" complete center. it's part number PRF-225. it has a 5.00 small pinion strange/US pro-gear, big 3.812 side bearings, 40 spline light weight spool, heavy duty billet pinion support & billet 1350 yoke. it has 10 runs on it from NEW & is in perfect condition. the 1st $1100.00 plus shipping gets it. it also has the strange container. any ?'s please E-mail me at [e...
i have a brand new magnafuel 500 pro-star fuel pumps with filter. it's part number #MP-4450. it's good for up to 2500hp. and have adj. 25-36 psi settings. it use a AN12 in and out. it also have a built in #an8 adj. by-pass. the are $460.00 each. it's in the sealed box. it comes with the factory warranty! any ?'s please call me at 1 312 502 6312 or E-mail me at [email protected]. Monee, IL 60449...
Small Block Chevy Edelbrock dual quad setup, 500 cfm carbs, progressive throttle linkage, fuel log, ready to bolt on and go. Will not fit with an hei distributor. No distributor included. Retails just over $1500. Asking $800 for intake and carb only. No engine included.. Palatine, IL 60074 (847) 812-3676
Up for sale is a 555 short deck BBC that was completed on June 14 and on the Dyno on June 17. Gen 4 Bowtie block with no block filler, 14.7-1 compression,JE pistons, hellfire rings, Eagle rotating assembly with L19 bolts. .810-.780 solid roller on a 112 centerline. Manley roller lifters .842 dia. Manley pushrods, Crane roller rockers with stud girdle. Older Reher-Morrison aluminum heads, full p...
454 bbc - Engine was rebuilt when I purchased in a project car but never ran. - Block# 361959 - Holley 750 carb (3310-2) - Edlebrock Torker II intake - 781 open chamber heads - Alternator, starter, water pump, and pulleys, motor mounts included - Flywheel and new Centerforce clutch included - New oil pan installed (815) 531-4567. Darien, IL 60561 (815) 531-4567
i have a brand new set of strange 11" rear drum brakes that are BRAND NEW and fit early big ford ends. they are part number B1608. they also have both 4 1/2" & 4 3/4" bolt pattern. again they are brand new and never used in any way. the 1st $250 plus shipping gets them. any ?'s please call 1 312 502 6312 or E-mail me at [email protected]. Monee, IL 60449 (312) 502-6312